***PLEASE NOTE*** If you have tried printing with your cartridge completely out of ink, you may have damaged the printhead. Inkjet printers work by heating a resistor inside the printhead which then heats up the ink before spraying it onto the paper. If there is no ink to keep these working, you could possible fry them.

Always refill before you are completely out of ink

There are two different types of these cartridges. The older type has a
single vent hole and the newer type has two vent holes.

1. Locate the vent hole on the cartridge. Using the drill tool, screw into the plug and pull it out.
2. Screw the needle on to the syringe and draw up the ink. The cartridge will hold about 15 to 17 ml of ink. Slowly and carefully inject the ink deeply into the internal sponge through the vent hole. It is a good idea to insert and withdraw the needle a little at a time to allow the entire sponge to soak the ink. Inject as deeply as possible.
3. Set the cartridge on something (ie: block of wood) that will allow the printhead to hang off the edge, allowing any excess ink to drip onto a paper towel. Let it sit until the cartridge stops dripping. Do not allow the printhead to touch the paper towe.l Reinsert the plug back into the hole and return the cartridge to the printer

Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.

You many need to leave cartridge in printer for up to 24 hours.

KITS AVAILABLE
ORDER CODE
SC2B Black Single Refil (2 x 20ml Bottles)
C2B Black Full Size Refill (100ml Bottle)
All kits come with tools and instructions

BULK INK AVAILABLE - no tools or instructions
60ml, 100ml, 250ml, 500ml, 1 Litre

All sold Seperately