***PLEASE NOTE*** Do not try printing with your cartridge completely out of ink, you could damage the printhead. Inkjet printers work by heating up a resistor inside the printhead, which heats up the ink before it is sprayed onto the paper. If there is no ink to keep these cool, it is possible to fry them.

Always refill before you are completely out of ink

1 Put the cartridges on some paper towels in an area where you can tolerate a spill. 2) Turn the cartridge up side down so that the outlet port of the cartridge is facing upward.
3) For Black - Fill the syringe with 5ml of black ink.
For Colour - Fill each syringe with 2mls of ink there is one syringe for each colour
4) Drip ink onto the felt pad in the outlet port. The felt pad will quickly absorb the ink into the cartridge. If the felt pad will not soak up any more ink and the ink just sits on top then that chamber is full.
Note: Do not pierce the felt pad the the needle of the syringe.
5) Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.

If necessary leave cartridge in printer for up to 4 hours to allow the ink to saturate the entire sponge.

KITS AVAILABLE
ORDER CODE for BCI-15
SC12C Colour Single Refil (3 filled syringes)
C12C Full Size Refill (20ml Bottles of each 3 colours)

ORDER CODE FOR BCI-15
SC3B Colour Single Refill (1 x 20ml Bottle)
C3B Full Size Refill (2 x 20ml Bottles )
All kits come with tools and instructions

BULK INK AVAILABLE - no tools or instructions
60ml, 100ml, 250ml, 500ml, 1 Litre

All sold Seperately

Back  Main