***IMPORTANT NOTICE*** Do not try printing with your cartridge completely out of ink, you could damage the printhead. Inkjet printers work by heating up a resistor inside the printhead, which heats up the ink before it is sprayed onto the paper. If there is no ink to keep these cool, it is possible to fry them.

Always refill before you are completely run out of ink.

Instructions: Wear old clothes and use newspapers or paper towels to work over.

1.The fillingr holes of the cartridge are located under the top. Remove the top before refilling by carefully prying it off with knife.
2. Check the colour chambers with a clean needle before putting injecting the ink. The chambers will be white and dry and you will have to push the clean needle in far to get the ink in it.
3. Insert the needle with the ink into the holes of the colour
4. Slowly inject up to 8ml. of ink until the sponge is saturated.
5. After refilling the top can be put back on with some tape.
.
Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.

If necessary leave cartridge in printer for up to 24 hours. (This will allowas ink to flow to the print head).

Back   Main