***IMPORTANT NOTICE*** Do not try printing with your cartridge completely out of ink, you could damage the printhead. Inkjet printers work by heating up a resistor inside the printhead, which heats up the ink before it is sprayed onto the paper. If there is no ink to keep these cool, it is possible to fry them.

Always refill before you are completely run out of ink.

Instructions: Wear old clothes and use newspapers or paper towels to work over.

Black Cartridges

1. Using the Thumb Drill included enlarge the filling hole on the top of the cartridge. (Do not remove the cap).
2. Fill the syringe with ink, insert the filling needle into the filling hole and push as far down into the cartridge as it will go. Inject approximately 15ml. of ink SLOWLY or until the reservoir is full.
3. Set above a paper towel for half an hour as a drip precaution. Expect a few drips. Do not allow the cartridge to touch the paper towel at this point, since the towel will draw out the ink.
4. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
If necessary leave cartridge in printer for up to 24 hours. (Allows ink to flow to the print head).
Note: Immediately refill any empty cartridges.
A Refill Kit should include Ink plus the following:
1 Syringe
1 Thumb Drill.

Back   Main